+86-515-88811626
Home / Knowledge / Details

Nov 17, 2021

Causes of engine limp protection failure

1. Circuit failure: the sensor and wiring harness mentioned above are in poor contact or short circuit or open circuit. (Get the fault type through diagnosis, flash code or display screen).

2. Oil circuit failure: fuel tank filter → fuel water cold treasure → coarse filter element → fine filter element → small filter screen of the low pressure oil inlet pipe of the high pressure oil pump. If the gas vent of the fuel tank is not cleaned for a long time, the fuel tank similarly forms a vacuum, resulting in poor fuel supply. (Filter element, oil pipe joint, filter element exhaust bolt) The fault point is the inspection of the oil supply passage.

3. Air circuit failure: engine air filter element (the air filter is basically blocked due to dirty ballast road and catkin dust) → air intake pipe joints and rubber pipes are damaged, the clamps are loose, and the booster pipes cause insufficient engine air intake (intake Air pressure) is insufficient, the engine power is insufficient, and the maximum speed can only reach 1500 rpm when running after loading.


Send Message